Having an issue with very stiff hydro pedals. I think it is a lubrication issue as the zerk will not take grease easily. I checked the zerk itself and it is good, I did attempt minimal heat but because of the location (close to the floorboards) it is not easy. Any suggestions? Thanks.
GC1710 hydro pedals stiff.
- Thread starter MoMower
- Start date
- Views: 1488
deanocraft
Silver Member
I would try to move the pedal while pumping in the grease.
DLTTrekkers
Veteran Member
Remove zerk and clean hole...replace zerk and ghrease wile moving pedal
Phillip w
Platinum Member
- Joined
- Jun 21, 2017
- Messages
- 776
- Location
- whiting ks
- Tractor
- allis Chalmers 185 and massey ferguson 1531
This guy has got it right. Follow his advice