gc2310 reconnecting BH

   / gc2310 reconnecting BH #11  
Had the Bh off and on again this weekend. Don't fear it gets easier each time you do it. This time was slightly more challenging because the ground was more unlevel where I disconnected it. My fault, but it did just take a little more this and that til it hooked up right.
 
   / gc2310 reconnecting BH #12  
I've had mine on and off a few times now too in order to use a box blade. I've found that it's much easier to reconnect it when I remove it on a perfectly level surface. So, I have a concrete pad where we used to park our 5th wheel camper (before we sold it) and that's where I drop the BH at. I can usually reconnect it probably less than two minutes. Wish I could say the same for connecting the box blade. :(
 
   / gc2310 reconnecting BH
  • Thread Starter
#14  
Thanks for all your replies. I did notice a bunch of junk in the saddles. I'll clean them out and give it a try.
 

Tractor & Equipment Auctions

24in pin on excavator tooth bucket (A56436)
24in pin on...
2020 INTERNATIONAL RH613 (A58214)
2020 INTERNATIONAL...
500 BBL FRAC TANK (A58214)
500 BBL FRAC TANK...
Bobcat S740 (A57148)
Bobcat S740 (A57148)
New Holland LB75B (A57148)
New Holland LB75B...
2020 John Deere 1025R MFWD Compact Tractor (A56438)
2020 John Deere...
 
Top