GC2410 TLB bucket tooth

[truenorth]

I looked at my CB05 bucket just now and one tooth is missing. I can find the part number but how do I install it? I've looked at various videos but they show a pin or set screw. I can't see any holes...

 

[cdaigle430]

You will have to weld it on, if\when I have to do the same I will weld the new tooth on. I do have a MIG welder, if you dont you can take the bucket off and bring it to a weld shop.

 

[mgstevens]

Yeah, it wasn't until the next series of BH they went to the bolt-on teeth. I wonder if you can update the bucket if the weld-on tooth is tough to find..?

The tooth part you found is likely the bolt-on for the newer bucket. There may be some custom fabrication needed to make it work.

I have the same bucket and am designing a "clean-up edge" to bolt-on over the teeth for ditch maintenance work.