GC2610 will not fit bushog????

[Wacky]

On this one there is no other holes, except where the bracket bolts to the support near the bottom.

 

[massey driver]

Just to give you some measurements of my GC2300 The lift arms while down are 5 1/2" to the ball centers and raised up there at 23 1/2" now my brush mower is resting on the ground its 15" to pin centers and 31" to the top link center. Not sure if your arms on the 2610 are set the same way.Larry

 

[Wacky]

Just to give you some measurements of my GC2300 The lift arms while down are 5 1/2" to the ball centers and raised up there at 23 1/2" now my brush mower is resting on the ground its 15" to pin centers and 31" to the top link center. Not sure if your arms on the 2610 are set the same way.Larry

Thanks Larry