gcfisher75
New member
Hi guys, recently picked up a new to me 2002 110TLB, long story short, bell housing was broke, tractor was taken apart bell housing welded (looks like a good job of the repair) was told the tractor moved after the repair but no longer does... everything to the rear of the tractor works properly, no weird noises, or anything like that so I'm thinking its a sensor/controller problem...
I bought a manual yesterday and today i tried to get it into auto calibration mode... when i move the f11 fuse into the f12 spot and start the tractor the light comes on steady as it is suppose to if i understand correctly, then when removed from f12 and placed back into f11, it still stays on, no flashing to start the forward pedal calibration.... Is the controller bad? any ideas?
I bought a manual yesterday and today i tried to get it into auto calibration mode... when i move the f11 fuse into the f12 spot and start the tractor the light comes on steady as it is suppose to if i understand correctly, then when removed from f12 and placed back into f11, it still stays on, no flashing to start the forward pedal calibration.... Is the controller bad? any ideas?
