half a PTO shaft eurocardan

[Builder]

Can I just buy 1/2 of a eurocardan driveshaft? The end that slips on the tractor pto is shot. Other 1/2 that goes onto flail mower is fine.

 

[sweettractors]

Can I just buy 1/2 of a eurocardan driveshaft? The end that slips on the tractor pto is shot. Other 1/2 that goes onto flail mower is fine.

Give me the Metric series # you have and I can come up with one. Ken Sweet

 

[Builder]

I don't see anything on it. The end I need fits a standard PTO output shaft on my Kubota. It's the "triangular" shaped slip uyoke

 

[gpflepsen]

My experience is that it's cheaper to just buy the whole unit.

 

[sweettractors]

I don't see anything on it. The end I need fits a standard PTO output shaft on my Kubota. It's the "triangular" shaped slip uyoke

Just give me the measurements of the ID of the yoke hole and how wide across the yoke is at its widest point. Then I need a measurement across the triangle shaft, measuring from the flat across the shaft 180 degrees. Wiill need length of shaft end to end. I may have a odd half shaft laying around? Ken Sweet

 

[Builder]

My experience is that it's cheaper to just buy the whole unit.

Is there on on-line source for them that's popular with TBN?