Harbor Freight/Pat's QCS

[jand38]

I just cancled my H/F order and have tried to find out how to order Pat's system and all I get is "page can not be displayed". I want to order it on this site but I may have to try a different site. HELP!!

 

[RollTideRam]

I just clicked "back" to the General Forums page. Next to the Customization is Pat's ad. I clicked it and it worked. They had a toll free number for international orders. If you can't get there post back and I'll get the number for you. JC

Here you go; International Orders: Please call (888) 243-4204 before ordering.

 

[jand38]

I can not pull any thing up on that dissussion form so please supply me with a phone # and I will use the way we old men feel best with "human voice contact" I am in Texas thanks

 

[milkman]

Here's the # Toll Free: 1-888-243-4204, good people to deal with.

 

[jand38]

Thanks to all I ordered by phone: Talked to a very nice young lady and with her southern and my Texas drawl I should have my merchandise shortly, this still leaves me puzzled for months I could have order by using this site and today that was not possible. I could only get "Page can not be displayed" oh well it is still good to be able to talk to a American who is just up the (road) from you instead of India. just a old retired Texan

 

[texasjohn]

You'll like Pat's Quick Connect System.... at least I do. Be aware that sometimes you will need a different power take off shaft and/or top link... because Pat's system lengthens the 3pt arms a little.... you will just have to see after you install the QCS if your implements still have sufficient drive shaft length going up/down hills... and if implements can still be set at the desired angle via top link. YOU MUST CHECK THIS. Also, I use a bungee cord to hold the lower 2 points together at the right distance apart while backing to an implement... rather than the bar that holds the arms apart....

 

[GeneD14]

I bought a "Pat's Easy Change" and it came UPS yesterday. I can't wait to try it out but I am going to be tied up until Wednesday.

No one said life is fair.

 

[jand38]

Did you get Pat's QH put on your tractor and how do you like it? I have not received mine yet.

 

[GeneD14]

Did you get Pat's QH put on your tractor and how do you like it? I have not received mine yet.

I installed Pat's Easy Hitch last night. I normally have to wrestle the mower or tiller to get it on. I really used to dread switching implements. Anyway after I installed the new hitch I carefully backed up to my tiller and pushed against the pins, lifted the hitch a little (from inside the cab with AC) and the lower links snapped shut around the pins. It was so easy I couldn't believe it. All I had to do was slip on the pto shaft and pin the top link and I was done with no prying, hammering, wrestling, or cursing!

 

[jand38]

Thanks for the reply mine was suspose to be here today but???? I was hopping you would make that kind of statement I am sure my experence will be the same than I will need to add a HYD top link and this old man will be happy