Has anyone make a weed drag?

   / Has anyone make a weed drag? #1  

jodebg

Platinum Member
Joined
Mar 4, 2012
Messages
671
Location
New Hartford, CT
Tractor
Kubota B-2650
Thinking of making a weed drag and hoping someone has done so and can share some
ideas and experiences.

I've seen instructions online for making one out of a pallet and using screws to dig into
the sand road to sever the weeds.

Thanks
 
   / Has anyone make a weed drag? #2  
I made one. I used 7 old car snow tires. Four wide bolted together with short 3/8 all thread cut 3" long with 3/16 thick 2x2 homemade washers. This came out to about 8'6" wide total. I placed another row of 3 tires in front of the line of 4 tires. At each tangent point I bolted them together. About 7' of old chain, the ends bolted on either side of the center tire of the row of 3 tires. A loop bolted in the chain at the center that will go over a 2" trailer ball or in a shackle.

Of course the good grass lies over with the weeds, but the good stuff seems to bend and come back sooner. The weeds tend to break and not come back well. At that it may take several passes over the summer to damage the weeds to where they don't recover.

Of course this rig works well breaking up cow pies and horse apples. I'm sure there are better implements for these jobs, but this was incredibly cheap for the good job it does.
 
 

Tractor & Equipment Auctions

2006 JLG 2030ES 20ft Electric Scissor Lift (A51691)
2006 JLG 2030ES...
2016 J&M 1122-20T X-Tended Grain Cart (A50657)
2016 J&M 1122-20T...
2016 Chevrolet Tahoe SUV (A51694)
2016 Chevrolet...
GENERAC ST20-S 2IN WATER PUMP (A52472)
GENERAC ST20-S 2IN...
2001 Dodge Ram 3500 4x4 Knapheide Flatbed Truck (A51692)
2001 Dodge Ram...
2013 UTILITY VS2RA 53FT REEFER TRAILER (A52141)
2013 UTILITY VS2RA...
 
Top