Zork
Veteran Member
- Joined
- Dec 14, 2003
- Messages
- 1,103
- Location
- Virginia
- Tractor
- '04 Branson 3520, '51 Fergy, '96 MTD 18/46, '02 Craftsman GT5000/48
Anyone know that the valve clearances are for an '06 35 hp Kukje? I was looking through my manuals and I cant find any spec's.
Additionally, are the head bolts the stretch type that do not need torquing or do they require torquing at the "tighten nuts and bolts intervals" at the prescribed hours? I know this doesn't apply to every bolt, ie: rods, flywheel, etc, because that would be impossible.
I do not have any noise in the valves; or head leakage at the gasket but I would just like to know if they should be done on PM?
Additionally, are the head bolts the stretch type that do not need torquing or do they require torquing at the "tighten nuts and bolts intervals" at the prescribed hours? I know this doesn't apply to every bolt, ie: rods, flywheel, etc, because that would be impossible.
I do not have any noise in the valves; or head leakage at the gasket but I would just like to know if they should be done on PM?