How do you set display on 75C to mph and not metric

[kthompson]

Tractor is just over a year old and dealer said they have no idea how to change the display. May be over looked it in manual but don't find it there.

 

[oosik]

Number 1 - call an alternate dealer. Number 2 - a two year old 75C WILL have a method for the operator to change the display. Check your manual again. If your manual is anything like mine - it's a difficult conversion from Japanese to English.

 

[Egon]

Learn metric and the conversion factors.

 

[Bryan 45]

from my 75A operator manual, page 3-41 shows the following-

Speed Unit Setting
In order to display the programming menu, press the
switch (2), (B) icon for more than three seconds. Release
the switch.
Press the switch (3) on the icon (D) until the speed unit
symbol appears on the screen.


As much as I like the tractor, the operator manual is terrible.

 

[ovrszd]

Learn metric and the conversion factors.

Nope, not gonna do it. And not going to worry about it when using a tractor. Like Ken, I'd figure out how to change the display.

 

[kthompson]

You know me too well Richard. lol

Bryan, that you very much. Well see about that ASAP.

 

[Sonny580]

I just used the neighbors 2 year old 75 and it looks like he has everything set for American in it. --- The pto and speedometer was showing mph and rpm. in the screen. I have no idea how they would set them.

 

[fried1765]

Learn metric and the conversion factors.

A LOT of us in the USA are too old to bother with learning the metric system, particularly since the metric system is only sporadically used in the worlds largest economy.
When the metric clock is accepted world wide, that will be the time for me to adapt!

 

[MaximizerMatt]

You set it through the arrow rocker buttons on the dash...Bryan's got you covered. Not hard to do. Had a customer once who asked me about it on a Powerstar 75 I sold to him and I had to look it up in the manual, too. Then I went and fixed all the other new tractors on the yard, haha.