Got a 359 saw that has developed an issue. It will saw like a champ and then big down then run like a champ. Sometimes it will bog down to where it will shutoff and when you start it right back up it saws like a champ again. Sometimes though it will not start till it cools down 10 minutes. Any ideas. I changed the plug, air filter and fuel filter
Husky 359 bogging
- Thread starter trado
- Start date
- Views: 2595
Winmac
Gold Member
- Joined
- Dec 31, 2011
- Messages
- 366
- Tractor
- Landini 6860
The next thing I would do is check the fuel line for cracks or pinholes, after that I'd put a rebuild kit in the carburetor. Renewing the diaphragm and fuel pump gaskets will fix 90% problems I see with chainsaws.
Bluegill2
Veteran Member
- Joined
- Jan 21, 2012
- Messages
- 1,876
- Location
- Success Missouri
- Tractor
- Kubota L3800DT, L3750DT Shuttle
Like said, fuel line first. I'd just replace it if it's more than a couple years old.
If that doesn't do it, it's likely a bad carb. Some of these saws have a carb problem and need not just a rebuild kit, but the 'right' rebuild kit. Been discussed to death on the big chainsaw forum.
If that doesn't do it, it's likely a bad carb. Some of these saws have a carb problem and need not just a rebuild kit, but the 'right' rebuild kit. Been discussed to death on the big chainsaw forum.
