Hydraulic detent
- Thread starter psj12
- Start date
- Views: 1529
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
It's been done. I believe there was a recent thread here about it on a CK or possibly a DK series. It will not affect function except that it will make it necessary to hold the lever to choose flow or no flow from the remote.
k0ua
Epic Contributor
The dealer did mine, he returned them to me in a bag. He was very cautious about warning me about the dangers. As I did not have a need to run a motor or splitter, I let him take them out. But I don't know how involved it was.
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
They're Youtube videos showing how it's done on a DK-40. It requires removing the seat and metal plate it attaches to, then removing the bolthead in the valve which holds 3-4 detent balls and a spring. Then reassembly and done. No more detented valve.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
http://www.princehyd.com/Portals/0/valves/LvManual.pdf
Look at this PDF.
It is a Prince valve, but you will see the springs and balls that fit in a groove.
Just remove the spring and balls, and reattach the can and you will be with out detent.
Throw a small magnet in the bag to keep all the balls and springs together for later use.
Look at this PDF.
It is a Prince valve, but you will see the springs and balls that fit in a groove.
Just remove the spring and balls, and reattach the can and you will be with out detent.
Throw a small magnet in the bag to keep all the balls and springs together for later use.
seacap04
Gold Member
I have a front snow plow and redirect the rear remotes to the front. I did mine and it is not hard to do. There are threads on here that document how to do it. And yes the search function leaves a lot to be desired.
kco
Veteran Member
Here is a link to a thread for removing Kioti detentes. There are good photos and instructions.
http://www.tractorbynet.com/forums/showthread.php?t=228110
http://www.tractorbynet.com/forums/showthread.php?t=228110
