dalmgren
New member
I have a Yanmar 1300d. Can anyone help me with How to control the speed and lifting capacity for my attachments on this?
Regards, Darrell
Regards, Darrell
Oil & Fuel Hydraulic pressure and speed
- Thread starter dalmgren
- Start date
- Views: 1732
rmacAU
Member
- Joined
- Sep 11, 2006
- Messages
- 48
- Location
- Denmark, Western Australia
- Tractor
- Yanmar F18D and Mitsubishi D1550FD
The adjustment on my F18D is the knob above the one arrowed.
Yours could have a similar adjustment in the same position.
rmacAU may be correct but I would go slow with that adjustment. Those older models can be dead headed if not careful and destroy the pump. I believe you have a T handle in the same location as rmacAU's round handle. I also believe it is to be used only for locking the 3 point in the up position and not for speed adjustment. It may be possible your 3 point control valve has a little lever on the side of it for adjusting down speed. I do not know this for sure, just putting something out there for you to look for. Note this control valve (probably not just like yours) and the little T handle on the side. See if you have anything that looks like that. Yanmar Tractor Parts: HYD VALVE _
Explain "control lifting capacity", I am slow. If I am understanding the question right it is controlled by a system relief valve.
Explain "control lifting capacity", I am slow. If I am understanding the question right it is controlled by a system relief valve.
