Hi guys
New on here today, i have an issue with my iseki tu1400f the arms on the 3 point linkage were siezed in the up position, so i lifted the housing from the top of the back axel, complete with arms etc. The piston was stuck in the up position. i released this cleaned all up and put all back together ok. the lift now operates, but up is noisy and very slow goes up in jerks, vibration from the smaller pipe (high pressure i think) could it be airlocked or something to do with settings? any help or diagrams would be very gratefully appreciated thanks Philip
New on here today, i have an issue with my iseki tu1400f the arms on the 3 point linkage were siezed in the up position, so i lifted the housing from the top of the back axel, complete with arms etc. The piston was stuck in the up position. i released this cleaned all up and put all back together ok. the lift now operates, but up is noisy and very slow goes up in jerks, vibration from the smaller pipe (high pressure i think) could it be airlocked or something to do with settings? any help or diagrams would be very gratefully appreciated thanks Philip