Builder
Super Member
- Joined
- Feb 22, 2006
- Messages
- 6,155
- Tractor
- Kubota, AGCO, New Holland LB
Anyone knowwaht Deere rates their cutting capacity on a 1518?
Can't find via google search.
Can't find via google search.
JD 1518 batwing mower cut capacity?
- Thread starter Builder
- Start date
- Views: 4772
Hollow
Gold Member
Wow, there's really nothing out there is it. I'm thinking it is 3" if the mower has stump jumpers on it.
Hollow
Gold Member
I'd take a 1518 over a Woods any day and I'm not a JD man.
This is a single wing model. Negiotiated price to $2,200!!!
I think that's a freakin steal. Haven't pulled trigger yet
Deck was repainted JD Green. There's some rust under some of the paint. There's a few minor rust pinholes in the deck where it held a little water up towards the front (looks like it was stored outside). None of the gearboxes leak. One of the stump jumper pans has a tear in the outer edge. I wonder if that will cause vibration?
May have had a bit of a hard life compared to the way I treat my equipment.
Still can't find cut capacity, but looks like it's strong enough for at least 2" material.
I think that's a freakin steal. Haven't pulled trigger yet
Deck was repainted JD Green. There's some rust under some of the paint. There's a few minor rust pinholes in the deck where it held a little water up towards the front (looks like it was stored outside). None of the gearboxes leak. One of the stump jumper pans has a tear in the outer edge. I wonder if that will cause vibration?
May have had a bit of a hard life compared to the way I treat my equipment.
Still can't find cut capacity, but looks like it's strong enough for at least 2" material.