JD 4052R third remote add on kit

elginfarm · May 1, 2023

Hi All,
I am trying to locate the JD parts kit or part# for an add on kit of hoses and fittings to extend a rear remote to the front . (fittings, hoses etc.) or a reasonable alternative. I could order hoses from Discount Hydraulic Hose, but I need a bulkhead fitting for the front of the tractor. Any help or suggestions would be greatly appreciated. Thank you.

chevyman29 · May 1, 2023

just get the 3rd function kit from wr long . it comes with everything needed and isnt hard to install . it runs about a 1000.00 but its complete.

i just put one on my cousin 4520 and other than having to pull the seat it was a easy install .

edit , it occured to me that you may have just been wanting front hydraulics , not necessarily a 3rd function. if that all you want then get the appropriate hoses made at napa and route them to the front . im sure you can find a generic bulk head plate online.

beenthere · May 1, 2023

You have the 3rd SCV and the rear remotes now? And you want to feed (extend) the rear remotes to the front of the tractor, or to the FEL?

I extended my rear remotes from my 3rd SCV to the front of the FEL so I could operate a grapple on my forks. Not sure just what you have in mind. I don't have a bulkhead fitting.

chevyman29 · May 1, 2023

https://www.amazon.com/Mounting-Bracket-fit-12-Bulkhead/dp/B09CWJD3V2

beenthere · May 1, 2023

Thanks chevyman29. Will look into that bracket.

chevyman29 · May 2, 2023

No problem.
You should be able to get the bulkhead fittings wherever you get your lines made

PCABE5 · May 2, 2023

I ran hoses from the rear 3rd SCV to the mid SCV bulkhead. From there I used the JD loader 3rd SCV hardlines and hoses.

elginfarm · May 6, 2023

Thanks everyone. I do already have the third remote. just asking for advice on running the hoses to the front. Chevyman, thanks for the bracket info.

beenthere · May 6, 2023

I ran the two hyd hoses to the front along the left side of my 4300. Put quick connector couplings at the FEL frame to tractor mounts. Works quite well.

To calculate length of hyd hoses needed, I ran the garden hose through that route and marked where the couplings needed to be, then bought the right length hyd hoses.