JD 4310 Rockshaft control stiff

[dfkrug]

Well, I ended up having to take the whole thing apart. It was frozen up where it goes into the casting on the left side. There were two shafts that were frozen.

You mean shafts #28 and #33 in KENNY's parts diagram above?

As mentioned, the 3-pt cyl housing collects dirt and moisture and easily
corrodes since the paint is so poor. I ran into this and noticed that the
rust had made it partially into the 3-pt cyl cap. Clean it off, is my vote.
I had over 1" deep dirt/mud in there.