the lift on my hinomoto c-144 is jerking when i raise it. doesnt matter if anything hooked to it or not. lift has plenty of power, but just jerks erratically. fluid looks clean, and level is full. it is a gear drive, not hydro so it just has one filter. could fluid and filter still be the cause, or does it need something else done?
jerking lift
- Thread starter bdunegan
- Start date
- Views: 2083
MrJimi
Elite Member, Rest in Peace
Try to lower your RPM's and let it warm up for about 5/10 minutes
Jim
Jim
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 3,891
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
bdunegan said:
Clean your hydraulic filter screen and replace the fluid.
Its the pump starving for fluid that makes it jerk.
according to repair manual, and everyones info, mine does not have a screen. it just has a spin-on automotive filter under fender on left rear wheel for hydraulics. supposedly fluid and filter was just changed when i bought tractor, and fluid looks clean. not milky at all. i will change all for the winter anyway. Does anyone know for sure if this has a screen by chance and where is it located?
