Dirt Moving Just a little job with BX 23 for fuel cost

[TroyR57]

Some one was asking about doing odd Jobs on the side with there Tractor. The photos are of a Job I did to clean up a local construction site. This is located between my home and the fuel station. I had been up fueling the tractor, along with a jerry can, and it cost almost $40.00. So when this opertunity to help cover that cost, I jumped. I had to clean up a site with lots of concret picses from a old side walk, and move dirt back into the area, and level it out.

Note this Job required NO Digging, If it had, it would have required pre planing, and calling
One Call in Louisiana, to have site Marked.

There were Power and phone lines buried in this area. But this Job also required lots of manual labor to make a finshed grade for sowing grass seeds.

I loaded the larger concret into the trailer and other junk to be hauled off.

Photos to follow, having trouble seeing them while this post is up, don't know why my computer does this.

 

[TroyR57]

Photos?

 

[radioman]

nothing like a little extra cash for a bit of your time. :thumbsup:

 

[CompactTractorFan]

Insurance? Taxes? Liability? Permits? License?


Haha...Just kidding!!! :laughing::laughing::laughing:


Good job!!! :thumbsup:

 

[CompactTractorFan]

Oh, and where is the 3200?

 

[TroyR57]

This Job was a day before the arival of the new toy. Also did this job under the General contractor, and was covered by Him.

 

[CompactTractorFan]

This Job was a day before the arival of the new toy.

Oh, I see...

 

[Johndeere3720]

Looks like you got a good deal. The best part, you got seat time! :thumbsup:

 

[TroyR57]

Kyle, also if you noitce the little BX fills up the area where work was being done. The B3200 with BH would have been just to big for this little job site. Also when doing a finsh grade I feel the little FEL on this BX with 48 inch bucket does a great job. Off course I am not telling you anything that you don't already know, with your BX25, makes a great tool for tight spots.

 

[CompactTractorFan]

Kyle, also if you noitce the little BX fills up the area where work was being done. The B3200 with BH would have been just to big for this little job site. Also when doing a finsh grade I feel the little FEL on this BX with 48 inch bucket does a great job. Off course I am not telling you anything that you don't already know, with your BX25, makes a great tool for tight spots.

Yeah, I guess it would be too big. There are even times when the BX seems way too big. Make sure to post some pics when you start doing some projects with the 3200...:thumbsup: