randelifus
New member
- Joined
- Jun 2, 2009
- Messages
- 1
i rebuilt the lift and bucket cylinders on my l225. the problem is that it took so long to get the seals that i forgot which way the seal packs faced. this is my first time doing this and trying to use common sense on how fluid should flow isnt making sense on how these cylinders are built. the drawings in my loader manual are not a good enough quality to tell. the large lift cylinder has a pack on the back of the rod and a pack in the cap at the other end. the bucket cylinder has a pack on the rod but the cap just has o rings. any help or links to info would be greatly appreciated.