Recently I acquired a Kubota B6200 with a B850 engine. After installing a battery the engine was cranked. The engine ran at full throtle and the accelerator nor stop lever had any effect. I removed the injection pump and discovered the "rack rod" (rod that slides back and forth to control fuel) was difficult to operate. My questions are:
1. Where can I purchase the "Rack Rod"? ( Ihave been told by a dealer that a new pump must be purchased.)
2. In the event the "rack rod" is damaged (pitted, etc) will it cause any problems if I lightly sand it in an effort to get it to operate smoothly?
Thanks in advance for your help.
Roger
1. Where can I purchase the "Rack Rod"? ( Ihave been told by a dealer that a new pump must be purchased.)
2. In the event the "rack rod" is damaged (pitted, etc) will it cause any problems if I lightly sand it in an effort to get it to operate smoothly?
Thanks in advance for your help.
Roger
