nbanders
New member
Hi guys:
I aquired an old Kubota B7100, that has been sadly neglected. It has a tiller mounted, but the bearing where the shaft enters the housing on the right side has dissintegrated. Got the shaft out, but it's badly messed up inside. There appears to be the inner races of 2 bearings on the shaft. My question is how to remove the remains of the bearings from the housing. There is what I first thought was a broken grease fitting on the top of the housing, but now I'm wondering if that is a retaining screw for the bearing assembly. Any help/advise would be greatly appreciated.
I aquired an old Kubota B7100, that has been sadly neglected. It has a tiller mounted, but the bearing where the shaft enters the housing on the right side has dissintegrated. Got the shaft out, but it's badly messed up inside. There appears to be the inner races of 2 bearings on the shaft. My question is how to remove the remains of the bearings from the housing. There is what I first thought was a broken grease fitting on the top of the housing, but now I'm wondering if that is a retaining screw for the bearing assembly. Any help/advise would be greatly appreciated.
