Kubota L3130 hydraulics

[J_J]

A remote valve with detent or a diverter valve could be used.

No voltage on the diverter valve, the fluid would flow to the 3pt.

Flip a switch and the diverter valve would shift the fluid to the Post pounder.

There are probably several different ways to accomplish the task at hand

 

[RFB]

This is on my L5740, but the 30 series is quite similar. The looped hose goes from PB returning to sump; when my BH is connected, the HP hose goes to the BH, and the return LP hose goes to the sump. The loop is there when no attachment is connected to complete the circuit.

I have since replaced the fitting in the photo with a 3rd Kubota in-line casting like the two remotes shown for a 3 stack setup; two remotes and the loop circuit.

Are the BH connections like rear remotes but without a valve? So when you take a BH off do you need to complete the loop with a hose? I am thinking he needs some kind of valve so he can divert the flow to the PD which would return directly to the sump but would be bypassing the hitch. Once the post is in just flip the valve to return the flow to normal and raise the hitch and go to the next post.