L3000DT hydraulics

Anonymous Poster · Aug 8, 2001

does anybody know where to tap into the system of a L3000DT for operating other
cylinders? has anybody done this? if so i sure would appreciate any information you
can give me. thanks.
william in wright city, mo.

Anonymous Poster · Aug 28, 2001

William,

You didnot mention if you had a loader on your L3000DT. I do on mine, and have been told by dealers, that you can hook up a spliter valve off the hydraulic control valve to your loader and use a separate hydraulic cylinder. You just give up use of your loader bucket if you use the other hydraulic cylinder.
Doug in Independence, Minnesota

mr_fixit · Aug 28, 2001

what doug says is true, we put a down pressure bush hog brand post hole digger on last week and that is how it worked you tie in the line that tilts the bucket and when you switch it you run your aux cyl off the loader handle if you dont have a loader then you come off the side of the lift cover i think contact your kubota dealer to be sure.

Anonymous Poster · Aug 29, 2001

yes i do have the FEL. but is there a place to tap off of that is not related to
the operation of the FEL?and where would be a good place to locate the
valve?
william