Looking at 3032E

[nirion]

My 3032e was delivered last month. Only has about 8 hours, but happy with it so far. Really all I have done is brush hog with a 5' mower and play a little bit. If you don't need all the bells and whistles, I see now reason why it wouldn't be a good fit. I actually wanted it to be lighter than the 3320 so it would be more able to act as a finish mower in the future, while still allowing me to go up in size from the 2320 I started looking at.

Good luck!

 

[msmud]

The 4wd shaft to the front axle is exposed and mine has some light rust on it. I house my tractor in a pole barn with open sides and a tarp over the machine, but evidently it has not been enough protection for the axle. Still, it's very superficial light rust and it has caused no problem. I have not caught any brush in it. Since lowering my tire pressures I don't run it in 4wd much anymore.

 

[firefighterjrm]

I was wondering has anyone heard of skid unit to cover the 4x4 drive shaft I crawled under a 2012 3038E which I assume is the same as a 3032E and the shaft was partial incased, I guess I am little concerned of damage to it after my last experince with my 2320 I really would like that thing protected even though I do not believe the problem from the 2320 was a shaft problem I believe the problem came from the front causing the 4x4 drive to break off inside the rear. Has anyone had any problems???