mdr38856
New member
Had this in another forum, hope to get better results here.
After the tractor gets warm, the 3ph will not raise. I pulled the filter to clean it, but it needs to be replaced. Where can I get one and the seal that goes over the filter cover plate? My filter is in the bottom of the tran case. It's cylindrical about 1-1/2" dia x 5-1/2" long.
What should I use to flush the system?
I haven't noticed any fluid leaks to the pump, but there may be a very small leak at the base of one of the 3PH arms. Could this cause the power lose to the lift?
After the tractor gets warm, the 3ph will not raise. I pulled the filter to clean it, but it needs to be replaced. Where can I get one and the seal that goes over the filter cover plate? My filter is in the bottom of the tran case. It's cylindrical about 1-1/2" dia x 5-1/2" long.
What should I use to flush the system?
I haven't noticed any fluid leaks to the pump, but there may be a very small leak at the base of one of the 3PH arms. Could this cause the power lose to the lift?
