Moog 410 U joints no go in 4100/4110/4115

   / Moog 410 U joints no go in 4100/4110/4115 #1  

al3

Silver Member
Joined
Apr 20, 2005
Messages
247
Location
Central Wi
Tractor
JD 4110, X500
Some conflicting info out there about Moog 410 u joints being an acceptable substitution for the OE M802832—they aren’t.
Key difference is the retaining clip location OE uses clips that attach to cup itself (see groove in second pic below), where the Moog is designed so the retainer is installed in a machined groove which does not exist in the OEM design.


Some slight dimensional differences as well

........................................................... Moog............................... OE

Length without caps installed ............ 1.960 in ......................... 1.972

Length with caps installed.................. 2.156.............................. 2.187

Cup OD ............................................. .789..................................788

The individual needle bearings are also different lengths

Moog has a grease fitting that screws into one of the caps. OE has none.
goodboth.JPG


goodcups1.JPG

goodmoog.JPG
 
Last edited:
   / Moog 410 U joints no go in 4100/4110/4115 #3  
"Some conflicting info out there about Moog 410 u joints being an acceptable substitution for the OE M802832"

The only conflicting info is that the MOOG 410 is a replacement for the M80283. The M80283 is the 4wd driveshaft u joint. The 410 is the u joint for the main driveshaft not the 4wd driveshaft. They work fine for the main driveshaft. I put in a set yesterday.
 

Tractor & Equipment Auctions

Super Material Lift MH1000 (A51039)
Super Material...
STIHL TS420 CUTQUICK SAW (A50854)
STIHL TS420...
2013 FELLING  SKINNYNECK TA LOWBOY (A50854)
2013 FELLING...
2006 Ford Crown Victoria Sedan (A50324)
2006 Ford Crown...
2009 JACK COUNTY 130 BBL VACUUM  TRAILER (A50854)
2009 JACK COUNTY...
1265 (A50490)
1265 (A50490)
 
Top