Need help with a TSC 16' electric hay elevator

   / Need help with a TSC 16' electric hay elevator
  • Thread Starter
#21  
hay con 2.jpg

What killed this ole conveyer was the brass bushing the held the shaft for the 12"v belt pulley and the 3" sprocket. The metal wasnt thick enough so I welded in a piece of angle iron for support. I found a flanged needle bearing to use instead a brass bushing. After installing the shaft and pulleys/sprockets I figured out I needed a pillow block bearing to keep the shaft from being pulled by the belt or chain.
 
   / Need help with a TSC 16' electric hay elevator
  • Thread Starter
#22  
hay con 3.jpg

I basically rebuilt the drive chain shaft completely due to all the bushings were shot and the shaft was worn. Sozzie helped me out with finding a new drive chain sprocket. Thanks again!! Next spring I need to make a shield for it. My wife about stuck her boot in the drive belt while moving hay. :banghead:

I ended up with $200 when it was all done. Thanks for all the input.
 

Tractor & Equipment Auctions

JMR Root Grapple (A49251)
JMR Root Grapple...
2012 TROXELL COMPANY  130 BBL VACUUM TRAILER (A48992)
2012 TROXELL...
1/4" Universal Quick Attach Plate (A47371)
1/4" Universal...
2018 Bobcat S650 Skid Steer (A49339)
2018 Bobcat S650...
2020 INTERNATIONAL MV607 26FT BOX TRUCK (A45678)
2020 INTERNATIONAL...
2008 Peterbilt 384 T/A Wet Kit Day Cab Truck Tractor (A46683)
2008 Peterbilt 384...
 
Top