Loader Newbie What's Wrong With this Picture?

   / Newbie What's Wrong With this Picture? #1  
Joined
Nov 15, 2017
Messages
29
Location
New York
Tractor
Massey Ferguson 1742 Hydro with cab
The hoses rub against the tire, especially when I cut the wheel hard. Are the length of these hoses set from the factory, or is this something the dealer fabricates? Any ideas how to get rid of the slack without actually shortening the hoses? Thanks
 

Attachments

  • 20180217_142906.jpg
    20180217_142906.jpg
    5.1 MB · Views: 287
   / Newbie What's Wrong With this Picture? #2  
I think your hoses are routed wrong. See the photos below.

1742b.jpg 1742c.jpg 1742e.jpg 1742d.JPG 1742a.jpeg

Bruce
 
   / Newbie What's Wrong With this Picture? #3  
Just take the slack out of them pull them up so their looped above that grey bracket that's holding them.
 
   / Newbie What's Wrong With this Picture? #4  
Might then need a couple strong zip ties to hold them up.
 
   / Newbie What's Wrong With this Picture? #5  
pull them up and tie them to the arm of the loader,
 
   / Newbie What's Wrong With this Picture? #6  
turn the fittings upward, then zip tie it to the gray "L" with a wide zip tie to hold in place and not dig into the hose.
 
   / Newbie What's Wrong With this Picture?
  • Thread Starter
#7  
Thanks Everyone Appreciate it
 
   / Newbie What's Wrong With this Picture? #8  
IMHO - Code54 has the correct answer. Should end up looking like the far right picture in bcp's posting.
 

Tractor & Equipment Auctions

2012 GENIE GTH-5519 TELESCOPIC FORKLIFT (A51242)
2012 GENIE...
2015 FORD F-250XL SUPER DUTY SERVICE TRUCK (A51406)
2015 FORD F-250XL...
2007 FREIGHTLINER BUSINESS CLASS M2 DUMP TRUCK (A51406)
2007 FREIGHTLINER...
2008 Ford F-250 4x4 Service Truck with Liftgate (A50323)
2008 Ford F-250...
COIL TUBING FRAME (A50854)
COIL TUBING FRAME...
INDUSTRIAL SAND BLASTER (A50854)
INDUSTRIAL SAND...
 
Top