Northern Tool Log Splitters

   / Northern Tool Log Splitters #1  

Big Joe

New member
Joined
Oct 27, 2009
Messages
15
Location
Fayette County, TX
Tractor
L4300DT
Looking for your comments (good or bad) on Northern Tools log splitters. I'm considering their 37-ton unit. Any other recommendations would be appreciated. I'm trying to keep my cost to $1,800 or less. Thank you.
 
   / Northern Tool Log Splitters #2  
I bought a Northern Tool pto log splitter 4 years ago and use it to split around 4 cords a year. It's robust enough, if a little slow, and has so far not presented any major problems. The only fault I've found is that the piston shaft is a little prone to rust, although this can be prevented if I remember to withdraw the piston fully after use so it's not exposed to the elements.
 
   / Northern Tool Log Splitters #3  
I know a couple guy,s that have them and their happy,but didn,t get the cheap honda motor they upgraded to the more traditional honda:thumbsup:Dave
 
   / Northern Tool Log Splitters
  • Thread Starter
#4  
Thanks for the information, guys. I think I will go ahead and get one. Good advise on the Honda engine.
 

Tractor & Equipment Auctions

WITTIG VACUUM PUMP (A50854)
WITTIG VACUUM PUMP...
2014 CATERPILLAR 277D SKID STEER LOADER (A51222)
2014 CATERPILLAR...
2017 Buick Encore (A50324)
2017 Buick Encore...
2014 RAM 5500 FLATBED TRUCK (A51222)
2014 RAM 5500...
2014 KENWORTH W900 MID-ROOF SLEEPER (A50854)
2014 KENWORTH W900...
2020 JLG 1732 16,755lb 4x4 High-Capacity Rough Terrain Telehandler (A49461)
2020 JLG 1732...
 
Top