NorTrac 204C New to me

[New River]

Hello everyone perhaps you can help, I've got a stupid question.
I purchased a 2004 NorTrac 204C super low hours from original owner.
I have the owner & part manuals but I'm trying to locate fuel lines and parts (the Arizona sun and heat did a job on these lines).
When I look under Circle G Tractors under the Nortrac 204 and 204C it list the engine models: 295T, LL380, TY290, TY295, Y380, which one do I have?

The manual says its a 204C, has the 3 cylinder diesel 20 hp, 4wd and the parts numbers for the fuel system are: YJY, YJP, YJT.

Again stupid question, so someone please point me in the right direction,

Thank you

 

[piper184]

Look at the engine ID tag to see which engine you have. It may be on the block or it may be on the valve cover.
Which fuel lines do you need to replace? I have had good luck with carefully cutting through the crimped sleeve at the connector and removing the old line. The connectors are barbed so you can buy fuel line and small hose clamps and put it all back together.

 

[Affordable]

Being a 2004 My best guess is its a Yangdong Y380T, we have the fuel lines listed by size, and length you need to know the overall length, and the fuel line sizes on each end EXAMPLE 12mm x 14 mm x 16 " long


We should have just about any part you may need for it

Tommy
Affordable Tractor Sales Co
"Your Jinma Parts Superstore"
Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company
979-865-4002

 

[New River]

Thank you both.
So Affordable, if I have the part number in my service manual, is there a conversion sheet to determine which line can be purchased?
Also I see a Y380 and a Y385T but no Y380T in the parts section.

 

[Affordable]

We have a parts manual for the Y380T engine, the fuel lines changed from hard lines to Stainless steel flex lines several years ago, there is no cross reference anywhere unfortunately,we keep them by length and size banjo hole on each end.You must have that info to get the hoses, if you do not have a caliper to measure now is the time to get one with a Chinese tractor, Harbor freight has them for $ 20.00 .Most hoses are 12mm to 14mm ends

Tommy
Affordable Tractor Sales
"Your Jinma Parts Superstore"
Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company
979-865-4002