PEX and floor drain
- Thread starter wedge40
- Start date
- Views: 6262
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Like I stated in a previous post, here in Michigan, drains in outbuildings are a no, when the drain, drains directly outside. If it's tied into a sanitary system, that's ok. Interestingly, storm water can drain undergrouind and exit at a lower level. Grey water can't.
In my situation, I can't have any slope to the floor because I'm setting machinery on it. The floor was laser levelled during the pouring phase and power trowelled with an epoxy top coat.
My contractor thought I was wacky when I specified 8" of 6 bag mix until he looked in the other building and saw what I was going to set in the new building. It's important that the floor is stable and level as possible. When working in tenths, every little bit helps.
The building I added on to has floor drains (prior to the Michigan Law) with appropriate slope. It's a PITA to accurately level machinery in 2 planes with a floor that slopes.
If I was one of my motorcycles in the new shop in the winter with the PEX system running, a floor squeege to push the water out the door and 20 minutes later the floor is dry and clean.....
In retrospect, I should have run another zone under the parking pad and driveway to the building with a temperature controlled servo valve to keep the snow and ice melted off. It don't take a whole lot of heat/bru's to melt snow and ice.
In my situation, I can't have any slope to the floor because I'm setting machinery on it. The floor was laser levelled during the pouring phase and power trowelled with an epoxy top coat.
My contractor thought I was wacky when I specified 8" of 6 bag mix until he looked in the other building and saw what I was going to set in the new building. It's important that the floor is stable and level as possible. When working in tenths, every little bit helps.
The building I added on to has floor drains (prior to the Michigan Law) with appropriate slope. It's a PITA to accurately level machinery in 2 planes with a floor that slopes.
If I was one of my motorcycles in the new shop in the winter with the PEX system running, a floor squeege to push the water out the door and 20 minutes later the floor is dry and clean.....
In retrospect, I should have run another zone under the parking pad and driveway to the building with a temperature controlled servo valve to keep the snow and ice melted off. It don't take a whole lot of heat/bru's to melt snow and ice.
SpringHollow
Elite Member
I have a floor drain that has a recessed ring around the outside to catch any oil drips etc. It can be cleaned prior to using the drain for washing. I wanted a floor drain for winter snow and in case i ever needed to wash the tractor in the winter. I am not sure a trap is a good idea. If the drain is not used a lot, that trap will start to smell.
Ken
Ken
BMod
Bronze Member
- Joined
- Sep 1, 2011
- Messages
- 71
- Tractor
- Long 610DT, White Fieldboss 37, Ferguson T-35, Super M, Minneapolis Moline Z
Pour some cooking oil in the drain, problem solved. I learned that one from a plumber.............
SpringHollow
Elite Member
Glycol solves traps evaporating dry. Doesn't cooking oil go bad over time?
Ken
Ken
