Replaced Hydraulic line, now loader hesitates.

[Osconda]

Busted a line the other day on the loader, so I had another one made and topped off the fluild that was lost. This line went to one of the cylinders that curls/dumps the bucket. Now when I want to lift or curl the bucket, it hesitates just over a second before the loader even moves. Didn't do this before. Wondering if there was something else I was suppose to do after replacing the line. /forums/images/graemlins/confused.gif

 

[JerryG]

Run the cylinders full length and then full retraction a few times and hold at the end of the stroke each time. That will get the air purged from the system.

 

[Osconda]

Thanks JerryG,

I'll give it a try.