Replacing RPM/Tach cable on DTC 360

[Lineman North Florida]

My tach cable broke on my Farmtrac DTC 360, so I replaced it after less than 5hrs of run time it appears that it has quit again, it is still attached on each end, so I'm guessing it has broke again. Are there any tricks to installing one of these or is there possibly another reason these RPM cables are breaking? Any thoughts?

 

[Rocky Hoffler]

Are you replacing cable as a unit cable and housing or just the cable using old housing its best to lube cable with grease when replacing it make sure its not kinked or in bind good luck

 

[Lineman North Florida]

Are you replacing cable as a unit cable and housing or just the cable using old housing its best to lube cable with grease when replacing it make sure its not kinked or in bind good luck

No I replaced the whole works with a brand new one and I routed it back just like the old one, I've been to busy to look at it but if I have to replace it again I will spray some cable lube down it. Thanks for the reply.