RS1200 tiller bearing

[Schultz]

I have an RS1200 tiller. The hub bearing for the tine shaft is shot and doesn't turn.
Does anyone know where I can order the parts for this? It's 2.833"OD x 1.380" ID

Thanks,
Tim

 

[larso1]

Shultz, you must have measured it with a digital caliper or micrometer? They should be metric bearings and the size is imprinted on the edge of the bearing race, in millimeters (I think IDxODxthickness) which would make it close to 35x72x?. I bought all of mine from a local hydraulic repair shop, but I'm sure you can find an on-line source, or maybe a nearby bearing and seal store.

 

[shimp]

i would take it to a napa

 

[1danny]

I have an RS1200 tiller. The hub bearing for the tine shaft is shot and doesn't turn.
Does anyone know where I can order the parts for this? It's 2.833"OD x 1.380" ID

Thanks,
Tim

Tim, I should have the bearings & seal for your RS1200 tiller.

Danny

 

[Schultz]

Thanks guys,
I did find an online source. Yes, it converts nicely to a 72 x 35mm bearing.
There seemed to be some other stuff in there but it was so chewed up I couldn't tell what it was. I'll send you an PM Danny.