RTV hand throttle cable routing?

[Wayne_H]

Can anyone send me a picture of where the hand throttle is supposed to route where it goes through the frame? Right now I installed it sitting on top of the frame, but that does not look right. I don't see a logical place for it to go, and the directions don't show it, they might as well be written in Chinese....

Thanks! Wayne

 

[R_Walter]

Can anyone send me a picture of where the hand throttle is supposed to route where it goes through the frame? Right now I installed it sitting on top of the frame, but that does not look right. I don't see a logical place for it to go, and the directions don't show it, they might as well be written in Chinese....

Thanks! Wayne

I installed mine under the frame so it could be zip-tied to the emergency brake per the instructions.

 

[Wayne_H]

R Watler: I did too, but it just seems to be hanging out in the open, several inches in front of the rear wheel. It is zip tied like they said, but not routed cleanly like all the other stuff.

Any chance you might be able to snap a shot of it?

thanks

Wayne

 

[R_Walter]

Mine was also hanging out in the open until I tucked it behind the rubber battery cover a little. You just have to be somewhat careful shutting the hydraulic bed from the raised position.

I wasn't able to make the collar fit at the attachment point to the throttle lever. How about you?

 

[Wayne_H]

I got the color to fit, but I had to squeeze it quite a bit. Any chance anyone with a factory installed hand throttle could post a picture of the routing where is goes near the frame on the battery side?

thanks!

Wayne