Hi Guys, I'm new here but did spot a question shown on the forum I believe back in 2014 regarding replacement times/blades for a Satoh Rotavator, mines a 2PR-1101S. Didn't appear to be any answer to that thread but just wondered if anyone had any information to date. I need to replace the tines but am unsure what exactly what they should look like as mine are basically worn to a straight blade with an evil point, they outside two do have a curve on them. These are fixed individually in a housing on the shaft by one single bolt, with a 10/12mm hole and approximately 22/25mm in width and approximately 220mm high. I know Satoh were taken over and produced by Mitsubishi at one point, but that's about all I can discover. Any help would be appreciated, as although it does cultivate to a degree, the straight tine do leave solid ridges between them in the ground.
Satoh Rotavator Replacement tines. 2PR-1101S
- Thread starter Baziscad
- Start date
- Views: 726
K5lwq
Elite Member
- Joined
- Aug 6, 2017
- Messages
- 4,822
- Location
- Mineola, TX
- Tractor
- Kioti LK2554, Branson 4815C, Satoh Beaver, Speedex
These folks have about as much knowledge as anyone in the United States. They normally can get parts or direct you to an appropriate source. Good luck.
