ajd187
Silver Member
I took delivery of my 1025R yesterday. I keep getting the "shift to neut" message when I am clearly in neutral because I can push it. So it won't start unless I wiggle the shifter and get lucky. Yesterday it was 8 times out of 10, now it's maybe 2 times out of 10. The only difference - today it is on flat ground (my driveway and garage) vs a slight incline/decline (my yard).
I am guessing it is also a small adjustment - works better this morning, but still a bit finicky going into N. I have a message into my salesman but he must have been off today since I didn't hear from him. but I can use the tractor so there is not a massive rush now.
Is there an adjustment I can do, and if so does anyone have a procedure? I temporarily disabled the seat switch (no safely lectures please ) and this seemed to help, but sometimes I have trouble finding L and N. There is a lot of play in the lever for one thing, not sure if it is that, or something else.
I am guessing it is also a small adjustment - works better this morning, but still a bit finicky going into N. I have a message into my salesman but he must have been off today since I didn't hear from him. but I can use the tractor so there is not a massive rush now.
Is there an adjustment I can do, and if so does anyone have a procedure? I temporarily disabled the seat switch (no safely lectures please ) and this seemed to help, but sometimes I have trouble finding L and N. There is a lot of play in the lever for one thing, not sure if it is that, or something else.