Shifter On 65
- Thread starter day52
- Start date
- Views: 1295
silvertramp
Gold Member
It's been awhile since I owned my Perkins 65. I used to reach into the tranny with long screwdrivers and unscramble the gears. Dealer said to whack the shifter down to help prevent re-occurance. I used to do it- it works. This is all from memory, so proceed with caution.
massey driver
Gold Member
- Joined
- Aug 15, 2009
- Messages
- 452
- Location
- north of winnipeg canada
- Tractor
- massey 175,1655 BX 2370-1
If you lift up the rubber boot [if yours still has it] on the shifter rod.Look at the housing and you should see a pin that you can drive out with a punch.When your doing this remeber when you pull the punch back out the shifter rod will jump out as its spring loaded.Once you have the shift rod out you'll beable to line up the slide rails both in the center and it'll be in netural.To keep this from reaccuring one fix is to add a bit of weld onto the end of the shift rod[the end that moves the slide rails] don't add to much as it won't shift.Larry.
John from the valley
New member
- Joined
- Oct 6, 2009
- Messages
- 8
- Location
- the Ottawa Valley, Ontario, Canada
- Tractor
- 1957 Massey-Harris-Ferguson TO-35, 1964 MF 65
I had the same problem. By taking off the shifter boot and pin like "Massey Driver" suggested, and also taking out the filler plug (right beside the shifter on my 65) I was able to free up the linkage by putting a screw driver in and wiggling the linkage while wiggling the shifter. Good luck.
P.S. I'm told if you push down on the shifter when changing gears this is less likely to occur)
P.S. I'm told if you push down on the shifter when changing gears this is less likely to occur)