realtaildragger
New member
Does anyone know the size of the front PTO shaft (crankshaft extension) on a 3 cylinder 25HP L245 tractor. Is it 7/8 dia by 13 teeth? Too cold (lazy) to crawl under. Thanks
Size of L245DT front PTO shaft?
- Thread starter realtaildragger
- Start date
- Views: 4721
LawMan
New member
I didn't know there wuz one??? Only had mine about four months..but have greased the FEL, hmmm...as the Cajuns south of I-10 say-now you got my curious up?? /forums/images/graemlins/confused.gif
OP
realtaildragger
New member
Waaaaal.... Guess i am gonna have to crawl under and take a picture. I recently bid on this hydraulic pump http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=7500612102&rd=1&sspagename=STRK%3AMEWN%3AIT&rd=1
but lost the bid on the sprockets and chain that drive it. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=7500613282&rd=1&sspagename=STRK%3AMEWA%3AIT&rd=1
But, i think the spline is a readily available one if i could just nail down the size.
Five minutes later and and a trip out to the Bota with camera, wallah! ... see photo of shaft attached to this post & next.
but lost the bid on the sprockets and chain that drive it. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=7500613282&rd=1&sspagename=STRK%3AMEWA%3AIT&rd=1
But, i think the spline is a readily available one if i could just nail down the size.
Five minutes later and and a trip out to the Bota with camera, wallah! ... see photo of shaft attached to this post & next.
Attachments
OP
