TeamNH
Bronze Member
Hey guys,
07 NH TC34DA
I was out mowing trails a week ago and was using cruse control and worked fine. At the end of the day thou, cruse stopped working... it lights up when I try to set the speed like normal but then does not lock in. I did get the tractor temp up to the red... I was not paying due care to the temp like I should have been
, I shut the tractor right off when I seen it and cleaned all the cotton weed off the rad. After a bit, started it up and temp was in normal range and ran great.
I have not looked at it yet. I was hoping maybe someone here could give me a few ideas of were to start looking. Maybe a wire got disconnected? And idea's?
thanks in advance.
07 NH TC34DA
I was out mowing trails a week ago and was using cruse control and worked fine. At the end of the day thou, cruse stopped working... it lights up when I try to set the speed like normal but then does not lock in. I did get the tractor temp up to the red... I was not paying due care to the temp like I should have been
, I shut the tractor right off when I seen it and cleaned all the cotton weed off the rad. After a bit, started it up and temp was in normal range and ran great.I have not looked at it yet. I was hoping maybe someone here could give me a few ideas of were to start looking. Maybe a wire got disconnected? And idea's?
thanks in advance.
