Starting problems Mustang 2054 Skid Steer

[Dalis]

I were doing some work on it yesterday, and I found the voltage to the ignition switch to be a bit wierd. So I took a spare wire, and hooked it up from the batery, and to the switch.
Then it started, and I ran it for about 30 min without any problems.
When I took the wire away, it were just acting up again.

So I believe there is a bad wire who is to blame of the fault.

 

[Bob Rooks]

I were doing some work on it yesterday, and I found the voltage to the ignition switch to be a bit wierd. So I took a spare wire, and hooked it up from the batery, and to the switch.
Then it started, and I ran it for about 30 min without any problems.
When I took the wire away, it were just acting up again.

So I believe there is a bad wire who is to blame of the fault.

Excellent news, glad you got it running. Just be sure you didn't circumvent any safety features without knowing about it.

 

[Dalis]

I found the connection under the cab to be a weak link. So after it were soldered, the machine is like new :thumbsup:

 

[Bob Rooks]

I found the connection under the cab to be a weak link. So after it were soldered, the machine is like new :thumbsup:

Good news. :thumbsup: