jbrumberg
Elite Member
- Joined
- Jan 22, 2006
- Messages
- 4,903
- Location
- Cummington, MA
- Tractor
- New Holland TC29DA, John Deere D130
So here I was yesterday in the middle of my raised stone flowerbed project with a rather large sized rock in the bucket when the FEL control knob came off in my hand
which kind of immobilized the project
and
. The problem area is where the knob attaches to (screws into) the adaptor plate which is made of cast aluminum and very cheap aluminum at that. I kind of "jimmy rigged" a repair using a 7/16" - 20 fine thread locking nut. I contacted Messick Equipment - New Holland - Kubota - Case IH - Tractor Parts, Sales & Service who immediately sent me a parts diagram via e-mail. Today I will find out the cost of replacement. I might just go out and buy some loctite for my repair . Jay
My thanks to Messicks for their responsiveness and support.
My thanks to Messicks for their responsiveness and support.