Hello again guys!! I've got my little TC30 up and going and am loving every bit of it.
I am installing a Loader on it and have fabricated the mounts. I've supported it all the way to the rear axle and am now ready to install the hydraulic lines.
Let me start by saying this used to have a loader on it at one point of time so everything should be on it.
There is a block on the left hand side of the tractor where the lines hook in at. There are three plugs in this block and I need help to figure out which go where. The only stamp that I can find is an O next to one plug and an S next to another. Does anyone know what these are for? Are all three of the plugs pressure plugs or is one of them a relief port. Can anyone trace down their lines or have a schematic for these three hoses?
Thank you so much in advance!!!
Chris
I am installing a Loader on it and have fabricated the mounts. I've supported it all the way to the rear axle and am now ready to install the hydraulic lines.
Let me start by saying this used to have a loader on it at one point of time so everything should be on it.
There is a block on the left hand side of the tractor where the lines hook in at. There are three plugs in this block and I need help to figure out which go where. The only stamp that I can find is an O next to one plug and an S next to another. Does anyone know what these are for? Are all three of the plugs pressure plugs or is one of them a relief port. Can anyone trace down their lines or have a schematic for these three hoses?
Thank you so much in advance!!!
Chris
