Terra Bite track cleats

[Cymraeg]

Hi, I'm looking for a way to improve the traction of a tracked skid steer to climb up steep mountin sides for land clearing and such like. The plan was to purchase a used Rayco C140 or c100 but they were out of my budget then I llooked at a steel tracked skid steer but Bobcat no longer produce them and Cat Super Track were very deere.
My next option is these clamp on type Terra Bite track cleats on rubber tracks, dose anybody use or know somthing about these- I thinck it will make the machine very rough to drive.
I would be very thanckfull of any suggestions Thank you.

http://www.skidsteersolutions.com/Terra_Bites_Track_Cleats_s/186.htm

 

[tonyoz]

Hi, I'm looking for a way to improve the traction of a tracked skid steer to climb up steep mountin sides for land clearing and such like. The plan was to purchase a used Rayco C140 or c100 but they were out of my budget then I llooked at a steel tracked skid steer but Bobcat no longer produce them and Cat Super Track were very deere.
My next option is these clamp on type Terra Bite track cleats on rubber tracks, dose anybody use or know somthing about these- I thinck it will make the machine very rough to drive.
I would be very thanckfull of any suggestions Thank you.

Terra Bites Track Cleats

Have a look at the Trackgrip thread just down the page.:thumbsup:

 

[GreensForestryMulching]

Have a look at the Trackgrip thread just down the page.:thumbsup:

The Trackgrip set up looks much easier to use! Than what the OP posted.

 

[Cymraeg]

The Trackgrip set up looks much easier to use! Than what the OP posted.

I've tried to contact them a few times and my dealer but did not hear a diky bird from them. are they in the USA or NZ.

 

[tonyoz]

NZ. I can try and contact them today if you like

 

[TrackGrip]

Woodbridge Equipment Parts, based in Mississauga Canada is the distributor for TrackGrip steel cleats. The TrackGrip attachment can be installed on all machines with track widths ranging from 12 to 36 inches. The “easy-fit” TrackGrip bars can be installed or removed on site within approximately twenty minutes by an operator. Models are available for steel track excvators ranging from 6 ton upwards; enquiries on 1800-263-2309 and sales@woodbridgeeqquipment.com.