timing on 24t john deer balerr
- Thread starter dgrdjrder
- Start date
- Views: 9553
i have a 24t but its a multi-step process that i cant explain without the book in front of my There is a TBN'er ZZ6 or something like that who seems to be a expert at these balers try him. if you get real stuck let me know and when I get home I can get my book out
Tx Jim
New Member
Trying to time a sq baler is one of the reasons an operators manual is a necessity.
Bring plunger head rearward on compression stroke by turning flywheel CCW,trip measuring wheel to engage knotter,when face of plunger head is center in forward feeder fork slot then measure from LH side of baler to tip of feeder fork(10-12"s), continue turning FW when needles are just starting up in bale chamber and are even with the channels that are in bottom of bale case,the points on face of plunger head face should be even with needles. If adjustment isn't correct needle lift drive that is at rear and re-adjust timing. HTH,Tx Jim
Bring plunger head rearward on compression stroke by turning flywheel CCW,trip measuring wheel to engage knotter,when face of plunger head is center in forward feeder fork slot then measure from LH side of baler to tip of feeder fork(10-12"s), continue turning FW when needles are just starting up in bale chamber and are even with the channels that are in bottom of bale case,the points on face of plunger head face should be even with needles. If adjustment isn't correct needle lift drive that is at rear and re-adjust timing. HTH,Tx Jim