Tips for removal of Injector Pump on 2610D

[rock2610D]

My manual for a 336 states that after the gov. linkage is disconnected, all you have to do is push the control rack to left and pull your pump. Pushing rack to left is supposed to give the nipple room to clear block.

This was not the case for my tractor. I had to remove the two studs that hold on fuel pump and rotate the pump 90 degrees counter clockwise to allow the "nipple" to clear block.

Hope this will help someone in the future.

 

[53T]

Hey, just ignore my private email. I just did not read ALL of your posts before mailing you.

Thanks for sharing.

53T

 

[rock2610D]

Just an update its not 90 degrees its 45 degrees CCW

Glad someone can use some of my hard earned data.