I have a 2003 TN75D equiped with servo assist on the PTO. About a year ago I noticed the PTO shaft begining to drift while not in use. The drift has now became fully driving. Now it turns all the time without being engaged. Their is no icon indicating the PTO is engaged. I have tryied to adjust the servo but to no avail. Has anyone had this problem?
TN 75 PTO will not Disengage
- Thread starter WMay
- Start date
- Views: 6289
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
See if the PTO output shaft can be turned by hand when the tractor has been shut off for several hours. If not, remove the external linkage to the cross shaft and see if the situation improves. I'd bet that if the PTO functioned properly and now does not, there is an internal problem.
