sidschroeder
New member
I recently purchases that I was told is a 1940 9N ford. It does not have a dip stick for the transmission or differential. How do you check the fluid level on this tractor and what type of fluid should I use when I change I?
Oil & Fuel tranmission oil type and level for 1940 9n
- Thread starter sidschroeder
- Start date
- Views: 3493
murphy1244
Super Star Member
- Joined
- Nov 25, 2011
- Messages
- 19,511
- Location
- Ohio
- Tractor
- Kubota 1120 RTV Kioti DK-40, MF-135, Ventrac 4500Y
:welcome: to TBN from Ohio
Midniteoyl
Super Member
- Joined
- May 20, 2013
- Messages
- 5,108
- Location
- N. W. Indiana
- Tractor
- Kioti CK3510SE HST, Ford 3400, Gizmow ZTR, Simplicity 7016H
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
some early 9n did not have a place for a dipstick ont he back right side inspection cover. instead some had one in the top of the trans cover.
in any case. common sump hyds, trans and diffy hold about 5g oil.
yuo can use 90wt gl1 - 3 oil found at nap or TSC.. 80w90 gl4/5 oil that is mt1 rated and / or states yellow metal safe, or just about ANY UTF fluid.. though ones meeting m2c134 spec are best.
pull a lower bolt in the inspection cover on the right or left side of the center section and fill till oil dribbles out there.
in any case. common sump hyds, trans and diffy hold about 5g oil.
yuo can use 90wt gl1 - 3 oil found at nap or TSC.. 80w90 gl4/5 oil that is mt1 rated and / or states yellow metal safe, or just about ANY UTF fluid.. though ones meeting m2c134 spec are best.
pull a lower bolt in the inspection cover on the right or left side of the center section and fill till oil dribbles out there.
