tried out the V blade

[laurencen]

agree to reprogram the Toolcat controller problem is the switches it works on now are the ones that control the rotation of the chute left and right plus raising and lowering the chute for the snow blower, the blade would be OK but the snow blower would be screwed, the module is what needs to be changed and they tell me they can not change the programming on the blade module its odd because the old series A Tool cat I added the factory pin connector to run the snow blower and blade, the switches were correct, left and right switches moved the blade accordingly and the middle l and r did nothing

 

[LD1]

Got a picture of the controller? Having a hard time understanding what you are saying without a visual

 

[ruffdog]

Another thread on the subject:

What controls are supposed to run the V-plow?

 

[laurencen]

yesterday we had another good dump of snow, add the 45mph winds zero visibility and this morning have 4 foot drifts, cleared a path on the driveway with the V plow but tonight have to mount the snow bucket to move it, just too much for the plow

this is the most snow in 10 years, enjoy using the toolcat but now its starting to get old, be good to put the mower on this summer